Table of Contents
Advertisement
Response Timeout
Response Timeout
Only used when a response is required from the host. While in Multidrop, if
the reader does not receive an ACK or NAK from the host after sending
Usage:
polled data, it will act on a fault. The reader can be set to wait indefinitely by
setting Response Timeout to zero.
Time the reader will wait before timing out if ACK, NAK, and ETX are
Definition:
enabled, and a host response is expected.
Serial Cmd:
<K143,response
Default:
2
(in 10mS increments = 20mS)
Options:
0 to 255 (A zero (0) setting causes an indefinite wait.)
2-26
timeout>
Quadrus EZ Reader User's Manual
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Quadrus EZ Reader and is the answer not in the manual?
Questions and answers