Mitsubishi Electric FR-A700 Technical Manual page 167

[Pr.] Name
Pr.CL Parameter clear 0, 1
ALLC All parameter clear 0, 1
Er.CL Faults history clear 0, 1
Pr.CH Initial value change list -
*1 Differ according to capacities.
6%: 0.75K or less
4%: 1.5K to 3.7K
3%: 5.5K, 7.5K
*2 Differ according to capacities.
5s: 3.7K or less
10s: 5.5K, 7.5K
*3 Write is disabled in the communication mode (network operation mode) from the PU connector.
*4 Set this parameter when calibrating the operation panel built-in potentiometer for the FR-E500 series operation panel (PA02)
connected with cable.
*5 The parameter number in parentheses is the one for use with the operation panel (PA02) for the FR-E500 series or parameter
unit (FR-PU04/FR-PU07).
*6 These parameters are communication parameters that are not cleared when parameter clear (all clear) is executed from RS-
485 communication. (Refer to page 441 for RS-485 communication)
PARAMETER
Minimum Setting Refer to
Setting Range Initial Value
Increments
1 0
1 0
1 0
- -
200
[Pr.]
Page
— Pr.CL -
— ALLC -
— Er.CL -
— Pr.CH -
Control Mode-based
Instruction Code
Correspondence Table
General-purpose
V/F control magnetic-flux
vector control
FC -
FC -
F4 -
- -
200
PARAMETER
2