Mitsubishi Electric FR-A700 Technical Manual page 160

[Pr.] Name
990 PU buzzer control 0, 1
991 PU contrast adjustment 0 to 63
Pr.CL Parameter clear 0, 1
ALLC All parameter clear 0, 1
Er.CL Faults history clear 0, 1
Pr.CH Initial value change list -
*1 Differ according to capacities.
6%: 0.75K or less
4%: 1.5K to 3.7K
3%: 5.5K, 7.5K
2%: 11K, 15K
*2 Differ according to capacities.
5s: 3.7K or less
10s: 5.5K, 7.5K
15s: 11K, 15K
*3 Differ according to capacities.
6%: 0.1K, 0.2K
4%: 0.4K to 7.5K
2%: 11K, 15K
*4 Write is disabled in the communication mode (Network operation mode) from the PU connector.
*5 The initial value differs according to the voltage class. (200V class/400V class)
*6 Differ according to [Pr. 71] setting.
*7 Set this parameter when calibrating the operation panel built-in potentiometer for the FR-E500 series operation panel (PA02)
connected with cable.
*8 The parameter number in parentheses is the one for use with the operation panel (PA02) for the FR-E500 series or parameter
unit (FR-PU04/FR-PU07).
*9 These parameters are communication parameters that are not cleared when parameter clear (all clear) is executed from RS-
485 communication. (Refer to page 441 for RS-485 communication)
PARAMETER
Minimum Setting Refer to
Setting Range Initial Value
Increments
1 1
1 58
1 0
1 0
1 0
- -
186
[Pr.] Option
Page
389 990
389 991
— Pr.CL
— ALLC
— Er.CL
— Pr.CH
Control Mode-based Correspondence
Instruction Code
Table
General-
Advanced
purpose
magnetic
V/F control magnetic-
flux vector
flux vector
control
control
5A DA 9
5B DB 9
- FC -
- FC -
- F4 -
- - -
186
PARAMETER
×
2