Mobile Alarm System - Swift Tourer Owner's Handbook Manual

ALAR M SY STEM

MOBILE ALARM SYSTEM

STINGER 310 ALARM (IF FITTED)
Introducing the new Sargent STINGER 310
series modular alarm system.
Based on new technology and a two year
design process, the Stinger 310 incorporates
ideas and feedback from users and experts
throughout the caravan and security industries.
Designed to be modular, the system can be
expanded by a forthcoming range of wired and
wireless accessories.
To ensure your STINGER 310 system is
operated correctly, please read all sections of
these instructions before attempting to use the
alarm. If you are unsure of any content, please
contact your supplier in the first instance or the
manufacturer direct.
Operation - using the key fob
Each STINGER 310 is supplied with two key
fob style radio controllers, which are used to
operate the alarm system. Each key fob has
four buttons which can be used as follows;
LED Torch button
Press and hold the button to
use the torch for night time
convenience
Arm / Disarm button
Press and release the button to
arm the alarm (one beep)
Press and release the button
to disarm the alarm (two short
beeps)
To arm the alarm without the PIR
movement sensor (if you leave
pets inside etc)
44
Press and hold the arm button
and release after you hear one
beep followed by two beeps
Awning Light button
Press and release the button to
turn the awning light on or off
(note: awning light control is an
optional feature not present in all
caravan models)
Programming Mode button
Press and hold the button for
10 seconds to access the 3
programming modes, which are
indicated by series of long beeps,
as follows:
One long beep
- Tilt sensor sensitivity adjustment
Press the arm/disarm button to select the
required setting. 1 beep = low sensitivity
for windy conditions. 2 beeps = standard
sensitivity (default). 3 beeps = High sensitivity.
Press the program mode button to move to
the next setting.
Two long beeps - Beeper volume
Press the arm/disarm button to cycle through
the 7 available volume levels. When you are
happy with the selected volume, press the
program mode button to move to the next
setting.
Three long beeps
- PIR movement detector sensitivity
Press the arm/disarm button to select the
required setting / pulse count. 1 beep = high
sensitivity 2 beeps = standard sensitivity
(default). 3 beeps = Low sensitivity for hostile
environments.
Press the program mode button again
to exit programming mode, which is
indicated by one extra long beep.