Front Locker And Sunroof; Bonded Roof; Adjust Tension Of Horrex Blind; Step On Hitch Cover - Swift Tourer Owner's Handbook Manual

FR ONT L OCK ER / SU N R OOF / R OOF /
S T EP O N H ITCH C OVER / C YC L E R A C KS

FRONT LOCKER AND SUNROOF

The front locker is made from ABS
thermoformed plastics, which are easy
clean textured surfaces. To ensure long
life and prevent damage you must not use
any cleaning materials including solvents or
aggressive cleaning materials. We recommend
the use of warm soapy water, applied with a
damp cloth.
Where a front sunroof is fitted, directly above
the front windows, it is recommended that the
blind be left open during use (or storage) in
high temperatures or direct sunlight, to avoid
a build-up of heat within this non-opening
window.

BONDED ROOF

The roof of your caravan is made from a
bonded construction. Care should be taken
when cleaning the roof not to walk directly on
the roof. If access to the roof is required the
weight of a person should be spread across
a larger area using a spreader board and
extreme care should be taken when working
at heights.
TO ADJUST THE TENSION OF
THE HORREX BLIND:
In each corner piece there is an cord tensioner
(see photo). By unscrewing the hexagon
screw, the cord can move through the cord
tensioner. When you pull the cord, the tension
will get higher, when you let it move back the
tension will get less.
174

STEP ON HITCH COVER

Where a step on hitch cover is fitted,
customers are reminded only to stand on the
designated areas, identified with black anti-slip
matting. Stepping elsewhere on the hitch
cover may result in damage to the hitch cover.
Models without a step on hitch cover are
not suitable for standing on and failure to
follow these simple instructions may result
in premature failure or cracking which will
not be covered by any guarantees (including
extended warranties).

CYCLE RACKS

The Swift Group allows the fitment of a two
cycle rack to our caravans and we have made
provision for fixing blocks on most models for
this purpose.
Due to the complex nature of a cycle rack,
the different models available and the need
to break into the habitation box (therefore,
having a potential of a leak), we suggest
this modification only be carried out by a
competent person, ideally, a Swift Group
dealer or Authorised Repairer.
Please be aware a cycle rack can not be fitted
onto a model where there is a rear escape
window. Please confirm this with your Swift
Group Dealer.
CARAVAN MOTOR MOVERS
The design and fitment of a caravan motor
mover shall be in accordance with the NCC
Code of Practice 305 and you should ensure
you receive a signed installation certificate of
compliance from the installer.
Failure to do so may invalidate
your warranty