Swift Tourer Owner's Handbook Manual page 139

Switching ON/OFF
• Switch ON by pressing button (1), 2s
• Switch OFF by pressing button (1), > 2s
230V AC operation
• Select "Mains voltage" by pressing button (2)
• Set temperature step by pressing button (7)
12V DC operation (vehicle's battery)
• Select "Battery voltage" by pressing
button (4)
• Set temperature step by pressing button (7)
Gas operation
• Select "Gas" by pressing button (3)
• Set temperature step by pressing button (7)
RMD 85x1 models
MES-appliances (manual energy
selection)
Electrical operation
1
2
3
To start the refrigerator, press button (1) for 2
seconds.
The refrigerator starts with the last selected
type of energy.
230V operation :
Press button (2) :
12V operation :
Press button (4) :
Gas operation
Gas operation :
Press button (3) :
The ignition process is activated automatically
by means of an automatic igniter.
i
preset cooling compartment temperature
and ignites again if the cooling compartment
temperature increases again. If the flame is not
lit after the first ignition attempt, the automatic
igniter repeats the ignition twice (duration 30 s)
at time intervals of 2 minutes. If the flame is not
lit afterwards, a fault is indicated.
Setting of cooling compartment
temperature
4
Select the desired cooling compartment
temperature by pressing button (7) .
Fig. 9
The LED display (8) of the selected
temperaturesetting is illuminated.
The scale starts with MIN position at the left
LED position (small bar = highest temperature)
and climbs up to MAX position at the right LED
position (large bar = lowest temperature).
Note: The temperature levels do not relate to
absolute temperature values.
Additional features
• The brightness of the display reduces after a
3
The flame extinguishes after reaching the
7
few seconds if no other buttons are pressed.
The indicator lights again if a button is
pressed. Press the button again to activate
the required function.
Fig. 10
8
Fig. 11
137