Swift Tourer Owner's Handbook Manual page 117

4. Starting the boiler
automatically
This function is used to start the
boiler automatically at a later point
of time. With automatic start, the
boiler works for 24 hours and then
stops. After that, it repeats the
automatic start once a week; at
the same day and time, as long
as the function is activated. For
automatic start to function, the
On/Off button must be set in the
OFF position.
5. Constant pump operation
With this function, the selected
pump is constantly operating. The
function is disconnected in the
factory setting. This function limits
access to warm water, especially if
not much heating is needed.
A
A
6. *Pump Auto / 12 V
In the Auto mode, the 230V
A
pump operates, and when 230V
is disconnected, the 12V pump
starts. In 12V mode, the 12V
pump is used even if 230V is
connected. The Auto function is
activated in the factory setting.
7. *Pump speed
The circulation pump's capacity
can be controlled from the panel.
Note: A pump with this control must be
installed in order that this function can be
used.
8. *LPG bottle full / empty
This function is used in
combination with the cylinder
changeover (DuoComfort or
Secumotion) and indicates if the
LPG bottle is full or empty. This
function can also be used to
control defroster heating of the
cylinder changeover using an
EisEx defroster.
Note: The cylinder changeover (DuoComfort
or DuoControl) must be installed in order for
this function to work.
9. Automatic temperature
increase (legionella)
At 02.00 at night (if the clock is
set) the boiler starts and works
according to "Warm Water" (see
section 5). This is in order to
reduce the risk of legionella. The
function is disconnected in the
factory setting
10. Offset (temperature
adjustment)
Using this function, you can
calibrate the temperature on
the panel if you notice that the
temperature (the stabilised room
temperature) is not the same as
the temperature shown on the
panel. This also applies to outdoor
temperature
115