Swift Tourer Owner's Handbook Manual page 150

C O O K ER OP ERATI ON
3. To light: Push in the control knob and turn
to full rate – see Fig.1. Hold a lighted match
or taper to the burner and push the control
knob in and hold. It is necessary to hold
the knob depressed after the burner has
ignited for approximately 10 - 15 seconds,
to allow the thermocouple probe to reach
temperature, before releasing the knob.
Should the flame go out when the knob is
released, the procedure should be repeated
holding the knob depressed for slightly
longer.
4. For models fitted with Spark Ignition the
procedure is similar except that the burner
can be ignited by depressing the ignition
button, which is located on the fascia. If
the burner has not lit within 15 seconds
the control knob should be released and
the burner left for at least 1 minute before a
further attempt to ignite the burner.
5. For simmering, turn the knob further anti-
clockwise to the low rate position.
6. To turn off: Turn the control knob until the
line on the control knob is aligned with the
dot on the control panel. Always make sure
the control knob is in the off position when
you have finished using the
hotplate burners.
OPERATION
Using the Electric Hotplate
Ensure the electricity is switched on.
The hotplate control is numbered from 1 to 6.
To turn it on, rotate the knob either clockwise
or anti-clockwise to the required position.
Position 1 is the coolest setting.
To turn the hotplate off, rotate the knob until
the line or pointer on the knob lines up with the
zero on the control panel.
The hotplate is a sealed construction and
transfers heat through conduction. For
maximum efficiency a correctly sized pan with
a flat heavy gauge base should be used. Pan
size should be the same or slightly larger (up to
1" / 2.5cm oversize).
Before using your hotplate for the first time, we
recommend that you prime and then season it.
148
To prime the Hotplate
Switch on the hotplate for a short period,
without a pan, to harden and burn off the
coating.
Use a medium to high setting for 3 – 5
minutes. A non toxic smoke may occur during
this process. Allow it to cool, then season.
To season the Hotplate
First heat the hotplate for 30 seconds on
a medium setting, then switch off. Pour a
minimal amount of unsalted vegetable oil onto
a clean dry cloth or paper towel, and apply a
thin coat of oil to the hotplate surface. Wipe
off any excess oil, then heat the hotplate on
a medium setting for 1 minute. Occasional
seasoning will help to maintain the Hotplate's
appearance.
WARNING
• Glass lids may shatter when heated. Turn
off the hotplate and allow it to cool before
closing the glass lid.
• Remove all spillage from the surface of the
glass lid before opening.
• The glass lid has the tendency to snap
shut towards the end of lowering.
This is caused by the travel lock action of
the hinges as it is activated.
Make sure all fingers are removed from
appliance when closing the lid.
CAUTION : The use of the electric hotplate
and gas hobs will generate heat. We
recommend, to avoid excess build-up of
heat around the cooker area, the window
is left opened when cooking to allow for
additional ventilation.
IMPORTANT
• Depending on specification, your appliance
may be fitted with a glass lid shut-off system,
which cuts off the power to all hotplate
burners (gas and electric) if the lid is closed.
• Ensure the glass lid is in the open and
upright position before turning on the
hotplate burners.