Electrical Faults - Swift Tourer Owner's Handbook Manual

3.8 Common Fault Table
Fault
No 230 volt Connecting lead between
output from PSU the site and Leisure Vehicle
not connected
RCD switched off
RCD not operating correctly
MCB switched off
No or deficient supply
from site
Other fault
Reverse Polarity Mains Supply reversed?
light is illuminated
on PSU
P OWER CO N TR OL SY S T E M FA U LT S
Possible Cause Proposed Fix
Check and connect lead as per 2.4C
Reset RCD as per 2.4D
Check supply polarity; if the RCD
continues to fail contact your Dealer as
there is probably an equipment or wiring
fault.
Reset MCB by switching OFF (down
position) then back ON (up position), if the
MCB continues to fail contact your Dealer
as there is probably an equipment or
wiring fault.
Contact site Warden for assistance
Contact your Dealer
The reverse polarity light is designed
to illuminate when the Live and Neutral
supply has been reversed / crossed
over. If the light illuminates there is a
problem with the site supply or the cable
connecting the supply to your vehicle. The
light is designed to work on UK electrical
supplies (where the neutral conductor is
connected to earth at the sub station).
If you are using your vehicle outside the
UK this light may illuminate when no fault
exists. In these cases consult the site
warden for advice.
81