Swift Tourer Owner's Handbook Manual page 85

No 12 volt output No 230v supply
from PSU
Charger not switched on
Battery not connected and /
or charged
Power button on control panel
not switched to on
Battery flat /
Battery fuse blown
Fuse blown
Equipment switched off /
unplugged
PSU overheated / auto
shutdown operated
Other fault
Pump not working Fuse blown
Pump turned off
Setting incorrect
3.11 Contact details
Sargent Electrical Services Limited, provide a
technical help line during office hours. Please
contact 01482 678981 if you require technical
help. For out of hour support please refer to
the tech support section of the Sargent web
site www.sargentltd.co.uk
Check all above
Turn charger switch on, switch will
illuminate
Install charged battery as per 3.4
Turn power on at control panel
Recharge battery, check fuses, check
charging voltage is present at battery
Check all fuses are intact and the correct
value fuse is installed as per fuse table
Check equipment is switched on and
connected to the 12v supply
Reduce load on system. Allow PSU to
cool down. PSU will automatically restart
when cool.
Contact your Dealer
Replace fuse with correct value as per
fuse table.
Turn pump on by pressing the pump
button at the control panel.
Both the internal and external pump
feeds are controlled from the control
panel. To alter the setting of the pump
switch see section 3.8
Ensure the setting matches your desired
requirement.
83