Plumbing Connections - Swift Tourer Owner's Handbook Manual

WAT ER TAN KS
To use the caravan with the internal
water tank:
• First prime the system as described for
using the caravan without water tank.
• Ensure that the external water container
is full.
• Connect the external pump to the upper
connection point on the outside of the
caravan, labelled 'direct to tank'.
• Ensure that the tank drain valve (which
is a Yellow handled valve identical in
appearance to the water heater drain
valve) is in the closed position - with the
handle horizontal.
• Rotate the handle of the White selector
valve clockwise to select internal tank as
the water source.
• Press the 'tank fill' button on the control
panel to transfer water from the external
container to the internal tank.
• Water will now be transferred from the
external container to the internal water
tank. The amount of water within the
internal tank can be checked by looking at
the water level gauge on the control panel.
• Once the control panel shows this level at
¼ or higher, taps can be used as normal.
• Press the 'water pump' button to switch
on the internal pump.
• When the control panel display shows
the internal tank as full, or the external
container is empty.
• Press the 'Tank Fill' button to switch off
the external pump. Refill the external
container if required.
To use the caravan with a mains
water connection:
• When using a mains water connection the
pump will still need to be switched on to
supply water to the water heater, taps
and shower.
• If a mains water connection is used,
please ensure this is a Truma Waterline
connection, which has a built in pressure
reducing valve.
52
• The Waterline connection should be
connected to the lower connection point
on the outside of the caravan, labelled as
'direct to taps'.

PLUMBING CONNECTIONS

In most cases, speed fittings are used, which
allow easy and quick connection of water
pipes
To connect a pipe to a fitting, simply push the
pipe into the connector. To remove the pipe,
push the collar of the fitting inwards, and then
withdraw the pipe.
To connect a pipe, simply push the pipe into
the connector.