Swift Tourer Owner's Handbook Manual page 101

this area may be subject to elevated
temperatures.
Important operating notes
The integrity and tight fit of the exhaust gas
double duct must be checked regularly,
particularly at the end of long trips. Also check
the mounting of the appliance and the cowl.
Following a blow-back (misfire) always have
the exhaust gas system checked by an expert!
Always keep the cowl for the exhaust duct and
combustion air intake free of contamination
(slush, ice, leaves etc.).
A number of hot air outlets and the recirculated
air intake openings must be free so that
the unit does not overheat. The integrated
temperature limiter blocks the gas supply
when the unit becomes too hot.
Operating Instructions
Always observe the operating instructions and
"Important operating notes" prior to starting!
The vehicle owner is responsible for the
correct operation of the appliance.
Before using for the first time, it is essential to
flush the entire water supply system through
with clean water. If the heater is not being
used, always drain the water contents if there
is a risk of frost. There shall be no claims under
guarantee for damage caused by frost!
Manual Controls
Sprite based models
Power selector switch
a = Power selection rotary switch
b = Electric operation 230 V, 1800 W
c = Electric operation 230 V, 900 W
d = Gas operation
e = Mixed operation* (900 W gas and electrical
operation)
f = Mixed operation* (1800 W gas and
electrical operation)
g = Yellow LED on = "Electrical operation"
* Winter mode only!
In summer mode the unit automatically selects
electric operation at the preselected electrical
power of 900 W or 1800 W.
Switching on the electric heating
elements as well does not increase the
maximum heating power.
Control panel
h = Rotary switch for room temperature (1 – 5)
k = green LED lit "Operation" green LED
blinking "after-running" is active in order to
reduce the unit's temperature
99