Swift Tourer Owner's Handbook Manual page 118

AL D E HEATI N G OP ERATIN G I N ST R U CT IONS
Note: To use this function, an external start
installation is required.
116
11. Button sound
With this function, you can
connect or disconnect the button
sound. The button sound is
connected in the factory setting.
12. Luminance
The luminance can be adjusted
between 1-10. The factory setting
is 2.
13. Language
This function is used to reset
the screen between different
languages. Available languages
are: English, French and German.
On the other hand, the service
menu is only in English (see
section 10.1).
14. Tools / Key
Under Tools / Key you can lock or
unlock access to the tool menu.
15. *External start
This function is used when starting
the boiler from the outside,
for example, with GSM. When
external start has been activated,
the control panel's On/Off button
must be switched off (see the
assembly setting manual for
external start).
*230 V
This function is used in connection
with starting the boiler when
connection of 230 V to vehicle
takes place from outside. When
the 230 V function has been
activated the control panel's on/off
button must be turned off, but
12V must be connected (main
switch on). Before turning off
the control panel with the on-/
off button set the parameters/
functions that you want the boiler
to have when it starts (230 V is
connected).
16. *Load monitor
This function is used to prevent
the 230V fuses being overloaded.
If the total power consumption
of the vehicle, boat or building
exceeds the set value, the boiler's
power will be automatically
reduced. On account of voltage
variations and tolerances, different
setting levels can be selected (for
example, for 6A fuse, one can
choose 6 or 7 Amp setting). If
the fuse does not hold, choose
a lower set value. The function
is disconnected in the factory
setting.
Note: The load monitor has to be installed
for the function to be used.
10. Service and resetting the system