Cooker 3 Burner And Hotplate - Swift Tourer Owner's Handbook Manual

Owner’s service and warranty handbook
Table of Contents

Advertisement

Operation with batteries
(internal power supply)
Indicator
Fault
(3) and (8)
Flame not ignited
flashing brightly
(3) and (7)
Burner defective
or cooling unit
flashing brightly
defective
Acoustic signal at
Undervoltage
15 second intervals
detection (internal
batteries)
Automatic
Refrigerator does
switching from
not function, gas
external to internal
operation not
power supply
possible although
does not function
the batteries are
(absence of the
inserted
onboard 12V power
supply for the
electronics)
COOKER 3 BURNER + HOTPLATE
OPERATION
Burner operation
Fig. 1
IMPORTANT
• Although each burner will support pans from
10 to 22cm, care should be taken not to
overload the appliance as performance may
be reduced.
• The following pan sizes are the maximum we
recommend:- Electric Hotplate:- Ø180mm
Auxiliary Burner:- Ø200mm
Semi-Rapid Burner:- 2x
Ø200mm or 1x Ø220mm with
1x Ø180mm
C OOK ER OP E RAT ION
Remedy
Check gas supply (gas bottle, gas valve)
Press the (8) button after clearing the fault
Check burner, burner nozzles, if necessary
contact Customer Service and arrange
replacement
Replace batteries
Switch off the refrigerator and start again
The onboard power supply was interrupted during
the starting of the gas operation
Note: No automatic switching is performed during
the ignition.
• When using small pans the flames should
not spread beyond the base of the pan as
this will reduce the efficiency of the burner.
• Avoid old or misshapen pans as these may
cause instability.
• The lid must be opened fully prior to using
the hotplate burners.
Using the Hotplate Gas Burners
1. Ensure gas cylinder/supply is connected
and turned on. In the event of a gas smell
turn off at gas cylinder/mains and contact
supplier.
2. Flame supervision: Each burner is
controlled individually and is monitored
by a thermocouple probe. In the event
of the burner flames being accidentally
extinguished, turn off the burner control and
do not attempt to re-ignite the burner for at
least one minute.
147

Advertisement

Table of Contents
loading

Table of Contents