Swift Tourer Owner's Handbook Manual page 48

ALAR M S YSTEM
ALARM SIREN
The STINGER 310 contains a dual sounder
unit that provides the loud alarm siren and the
volume adjustable beeper sound.
When the alarm is triggered the siren will
sound for 2 minutes. Following the 2-minute
period the alarm will then deactivate for 15
seconds and then rearm.
The alarm siren can be turned off at any point
by pressing the key fob arm/disarm button.
When the alarm is disarmed the Beeper will
sound two beeps to confirm the disarm. If the
alarm has been triggered during the armed
period the beeper will sound three beeps if the
PIR triggered the alarm or four beeps if the Tilt
Sensor caused the alarm. If you hear multiple
pips (short beeps) when you disarm the alarm,
this indicated that the internal backup battery
is low and therefore should be charged.
The beeper volume can be adjusted using the
key fob programming feature described earlier.
SYSTEM SPECIFICATION
System base unit:
• Supply voltage 6 to 15v DC
• Supply current 500mA max 5mA typical
• Operating temperature -5 to +30 deg Celsius
• Battery capacity 9Ah at 4.8v
• Siren output 110dB +/- 10% @ 1M
• Comprehensive interface connector (details
on request)
PIR movement sensor:
• Range 120 deg x 6M
Key fob controller:
• Range 6M typical
• Battery 2x CR2032 lithium button cell
• Typical battery life 1 year
46
SPARE PARTS & SERVICE
The STINGER 310 system is supplied with
two key fob controllers as standard, but can
accommodate up to four controllers per
system. Extra fob can be purchased from your
supplier of direct from the manufacturer, and
can be added to the system by following a
simple procedure.
For accessories, interface harnesses,
installation documentation, spare parts,
local supplier contact details or other service
information please contact: Sargent Electrical
Services Ltd. service desk on 01482 678981
during normal office hours.
Further technical information is available at
www.sargentltd.co.uk
For your reference
For future reference it may be useful to note
your alarm system serial number below, which
can be found on the sticker attached to the
alarm system base unit.
Serial number:
............................................