3.
Remove the four precision screws (M2 x 4) to detach the SW board assembly, insulating sheet H, two SW insulating
sheets B, and SW insulating sheet C.
SW insulating sheet C
SW bracket A assembly
SW insulating sheet H
SW insulating sheet B
4.
Disconnect the flexible board from the connector CN100 on the SW-1578 board.
5.
Disconnect the flexible board from the connector CN101 on the SW-1577 board.
6.
Disconnect the flexible flat cable from the connector CN100 on the SW-1577 board.
Flexible flat cable
CN100
SW-1577 board
7.
Install the removed parts by reversing steps of removal.
2-4-3.
SxS Lid Assembly
Preparation
1.
Remove the battery lid. (Refer to
2.
Remove the bottom cover. (Refer to
3.
Remove the inside panel assembly. (Refer to
Procedure
1.
Remove the two tapping screws (2 x 5) to detach the lid shaft retainer.
PMW-160/PMW-150/PMW-EX260
SW bracket B
SW insulating sheet B
SW board assembly
Flexible board
CN101
Flexible board
"2-2. Lithium
Battery".)
"2-3. Bottom Cover and Tripod
"2-4-1. Inside Panel
Precision screws
(M2 x 4)
Precision screws
(M2 x 4)
SW-1579 board
CN100
SW-1578 board
Washer".)
Assembly".)
2-6