Creating A Route Using Marks On The Chart Page; Inserting A Waypoint Into A Route - Standard Horizon CPN700i Owner's Manual

1. Move the ShuttlePoint knob or touch the screen over the top of one of the Waypoints
in a Route and tap on the
2. Tap on
3. Tap on an open Route number.
4. Press the
5. To create the new Route, follow the steps in the previous Par. 2.7.1 "Creating a Route
using Waypoints".
2.7.5

CREATING A ROUTE USING MARKS ON THE CHART PAGE

To create a Route containing Marks you first must create the Marks and show them on the
Chart page.
1. Move the ShuttlePoint knob over the top of a Mark that you wish to be the starting
point in the Route and press the
2. Next move the
be the next leg in the Route (see B).
3. Press the
means these Marks are selected into the Route (see C).
4. Repeat steps 3 and 4 until all Marks are entered into the Route.
You can touch the Mark on the display instead of using the
2.7.6

INSERTING A WAYPOINT INTO A ROUTE

1. Touch or move the
and tap on the
2. The line between the two Waypoints is turned into a dotted line.
3. Move the ShuttlePoint knob or touch the display in the desired location for the new
Waypoint: the line will "rubber-band", drawing a dotted line between the previous
Waypoint and the cursor, and another dotted line between the cursor and the next
Waypoint (see B). Once you have positioned the cursor at the location you want, tap on
it or press the
When in 3D mode, the 2D mode is automatically triggered. When a Waypoint is placed, the CPN Series
Chart Plotter remains in 2D mode.
CPN700i and CPN1010i Multimedia Chart Plotters
.
key.
ShuttlePoint knob until the cursor is over the Mark that you want to
key. You will notice a bearing line joins the first and second Mark which
ShuttlePoint knob to the navigation line between two Waypoints
Soft Key (see A).
rotary knob or the
Soft Key. The Edit Route page will be shown.
key (see A).
ShuttlePoint knob.
ShuttlePoint knob (if enabled) (see C).
Page 67