System Alarm Report; Advanced Settings; Navigate Menu; Loran Td - Standard Horizon CPN700i Owner's Manual

System Alarm Report

Displays the report of the four alarms: Arrival Alarm, Anchor Alarm, XTE Alarm and Depth
Alarm. When one of these alarms exists, a check mark is printed on the relative box. Once
the alarm condition is no longer present, the relative check mark is removed.
2.14

ADVANCED SETTINGS

The Advanced Setup menu allows customization of many GPS functions and NMEA
interfacing.
1. Press the
2. Tap on ADVANCED. While in this menu you will see many selections which are
described in the next sections.

2.14.1 NAVIGATE MENU

The Navigate menu allows customization of the Coordinate System (Loran TDs), Chart
Datum, Chart Orientation Resolution (angle the vessel has to change before the chart is
redrawn) and Static Navigation. See the following table:
Coordinate System
Chart Datum
Chart Orientation Res.
Static Navigation

Loran TD

The Loran TDs selection allows the CPN Series Chart Plotter to be set up so the user can
enter in LORAN TDs directly into the CPN Series Chart Plotter. After the TDs have been
entered, and the user changes to ddd mm.sss (Degrees Minutes and Seconds) the TDs will
be converted to Lat/Lon coordinates. To use the TD Coordinate System the user must set
up the Chain and Pair information of the TDs. If you do not know this information, refer to
paper charts that show the Chain and Pair information. See the following table:
CPN700i and CPN1010i Multimedia Chart Plotters
key, tap on Setup Menu.
: Selections are:
a.TD: Time Difference, based on Loran
b.UTM: Universal Transverse Mercator Grid
c.ddd mm.mmm: Degrees Minutes and Thousandths of Minutes
d.ddd mm.mm: Degrees Minutes and Hundredths of Minutes
e.ddd mm.ss: Degrees Minutes and Seconds
: Allows selection of Chart Datums. The default Datum is WGS 1984 as C-MAP
cartography has been compiled using the WGS84 Datum. A datum is a mathematical
model of the earth which approximates the shape of the earth, and enables calculations
such as position and area to be carried out in a consistent and accurate manner.
: Sets the angle the vessel has to change before the chart is redrawn. The default setting
is 30°. Example: if the vessel is heading 000T at a speed of 25 Knots, the display will
redraw:
a.In Home Mode the CPN Series Chart Plotter centers the location of the vessel in the
center of the display while it is displayed in the center or on the bottom of the screen
(depending on the setting). To keep the vessel in the center of the display the CPN
Series Chart Plotter will occasionally redraw.
b.If the vessel changes course greater than 330T or more than 30T the chart will be
redrawn.
: Sets up a threshold for the speed. When the speed received from the GPS is under the
selected value, the CPN Series Chart Plotter displays zero.
J
BY EPPESEN
Page 107