· COMPASS : Heading, Variation, Rudder Angle
The priority data source can be set following the procedure below:
1. Press the
2. Tap on ADVANCED. The Advanced Setup menu appears.
3. Tap on DATA SOURCE PRIORITY. The Data Source Priority menu appears.
There are 4 groups, GPS, DEPTH, WIND and COMPASS. In each group the top item
(indicated with "1") shows the data source with the highest priority for the related group.
For example in the following picture A, the input data source with the highest priority for
GPS is NMEA-0183: 1: NMEA-0183. But if the system does not receive GPS data from
devices sending it to NMEA-0183 input, it will try to read this data from devices
connected to NMEA-2000 bus, which is set as a second in priority: 2: NMEA-2000.
4. If you want to change the priority data source, tap on the desired source and it is shown
in the first position. For example tap on 1: NMEA-0183 and then in the following picture
B the input data source with the highest priority for GPS changes to NMEA-2000.
2.14.4 ENGINES NAME SELECTION
The Engines submenu allows you to name each instance of an Engine which is connected
to the NMEA-2000 bus. These name are displayed in gauges, in data boxes, in the data box
customization menu and in the Engine Alarm Report. The default Engine names are set to
"1", "2" and "3". To name the Engines follow the procedure below:
1. Press the
2. Tap on ADVANCED. The Advanced Setup menu appears.
3. Tap on ENGINES. The Engines menu appears.
4. Tap on ENGINE NAME that you want to edit. The touchscreen keyboard appears, it will
allow you to enter in the name of the Engine. Insert the desired name (6 characters long);
when finished tap on
2.14.5 INPUT/OUTPUT (NMEA-0183) CONNECTIONS
Refer to Chapter 7 "Connections" for wire description and connection examples.
CPN700i and CPN1010i Multimedia Chart Plotters
key, tap on Setup Menu.
key, tap on Setup Menu.
, the keyboard disappears.
Page 109