Quick Access To Alarms, Track And Ais Settings; Alarms; Track; Ais - Standard Horizon CPN700i Owner's Manual

2.1.5

QUICK ACCESS TO ALARMS, TRACK AND AIS SETTINGS

The Quick Access menu provides a short-cut to important menu settings related to Alarms,
Track and AIS, so you do not have to enter the Main Menu. The Quick Access menu can
be activated by pressing and holding the
pages:

Alarms

Selects and sets up audible and visual alarms.
Arrival Alarm
XTE Alarm
Depth Alarm
Anchor Alarm
Audible Alarm
Grounding Alarm
Grounding Alarm Range : Sets the length of the sector to be detected: 0.25Nm, 0.5Nm and 1.0Nm. The default setting

Track

Sets up the Track function to lay down a Track for a predetermined time or distance interval.
Tracking
Step Unit

AIS

Configures the CPN Series Chart Plotter to receive AIS data:
Display
Activation Range
CPA Alarm
CPA Limit
TCPA Alarm
TCPA Limit
For more information on these settings, please refer to the following paragraphs: for Track Par. 2.10
"Tracks"; for alarms Par. 2.13.10 "Alarms"; for AIS Par. 2.15 "AIS".
CPN700i and CPN1010i Multimedia Chart Plotters
: Alerts when the vessel is approaching a single Destination point or a Waypoint in a Route.
Available selections: 0.00 to 4.99Nm. The default setting is Off.
: Alerts when the vessel is deviating from a defined course. Available selections: 0.00 to
4.99Nm. The default setting is Off.
: Alerts when the received depth value from the optional FF525 50/200kHz BLACK BOX FISH
FINDER is lower than the selected value. Available selections: 0000 to 3278ft. The default
setting is Off.
: Alerts when the vessel's position changes more than the selected distance. Available
selections: 0.00 to 4.99Nm. The default setting is Off.
: Turns On (default) or Off the alarm beep.
: Looks ahead of the vessel's heading to see if a potential danger exists. When the Grounding
Alarm is enabled the CPN Series Chart Plotter will draw a triangle in front of the vessel on
the Chart page showing the area that is being searched. The safe depth can be set using
this function. The default setting is Off.
is Off.
: Turns On or Off (default) the Tracking function.
: Allows to select Distance (default) or Time.
: Turns the display of AIS Targets overlay on the cartography On or Off (default).
: Defines the range from the fix within which the AIS Target becomes active. The values
allowed are from 0.1 to 20Nm. The default setting is 5.0Nm.
: Turns On or Off (default) the CPA alarm.
: Defines the CPA limit. The values allowed are from 0.1 to 10Nm. The default setting is
0.5Nm.
: Turns On or Off (default) the TCPA alarm.
: Defines the TCPA limit. The values allowed are from 1 to 30 Min.The default setting is 10
min.
Intelligent key from Chart, Navigation or data
Page 39