Configuring Remote Log Messages; Command Usage - AMX NXA-ENET8-2POE Operation/Reference Manual

NTP Configuration parameters
• Mode
• Server
When the NTP client is enabled, the switch periodically sends a request for a time update to a configured time
server. You can configure up to five time server IP addresses. The switch will attempt to poll each server in the
configured sequence.
1.
Click Configuration, System, NTP.
2.
Enter the IP address of up to five time servers.
3.
Click Save.

Configuring Remote Log Messages

Use the System Log Configuration page to send log messages to syslog servers or other management stations.
You can also limit the event messages sent to specified types.
FIG. 32 System Log Configuration
System Log Configuration parameters
• Server Mode
• Server Address
• Syslog Level

Command Usage

When remote logging is enabled, system log messages are sent to the designated server. The syslog protocol is
based on UDP and received on UDP port 514. UDP is a connection-less protocol and does not provide
acknowledgments. The syslog packet will always be sent out even if the syslog server does not exist.
1.
Click Configuration, System, Log.
2.
Enable remote logging, enter the IP address of the remote server, and specify the type of syslog messages
to send.
3.
Click Apply.
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch
Enables or disables NTP client requests.
Sets the IPv4 or IPv6 address for up to five time servers. The switch attempts to
update the time from the first server, if this fails it attempts an update from the next
server in the sequence. The polling interval is fixed at 15 minutes.
Enables/disables the logging of debug or error messages to the remote logging
process. (Default: Disabled)
Specifies the IPv4 address or alias of a remote server which will be sent syslog
messages.
Limits log messages that are sent to the remote syslog server for the specified
types. Messages options include the following:
Info - Send informations, warnings and errors. (Default setting)
Warning - Send warnings and errors.
Error - Send errors.
Configuring the NXA-ENET8-2POE
43