Configuring DSCP Translation
Use the DSCP Translation page to configure DSCP translation for ingress traffic or DSCP re-mapping for
egress traffic.
FIG. 104
DSCP Translation
DSCP Translation parameters
• DSCP
• Ingress Translate
• Ingress Classify
• Egress Remap
DP0
• Egress Remap
DP1
1.
Click Configuration, QoS, DSCP Translation.
2.
Set the required ingress translation and egress re-mapping parameters.
3.
Click Save.
Configuring DSCP Classification
Use the DSCP Classification page to map DSCP values to a QoS class and drop precedence level.
FIG. 105
DSCP Classification
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch
DSCP value. (Range: 0-63)
Enables ingress translation of DSCP values based on the specified classification
method.
Enable Classification at ingress side as defined in the QoS Port DSCP Configura-
tion table (see page 183).
Re-maps DP0 field to selected DSCP value. DP0 indicates a drop precedence
with a low priority.
Re-maps DP1 field to selected DSCP value. DP1 indicates a drop precedence
with a high priority.
Configuring the NXA-ENET8-2POE
135