Displaying Lacp Port Statistics - AMX NXA-ENET8-2POE Operation/Reference Manual

LACP Port Status parameters
• Port
• LACP
• Key
• Aggr ID
• Partner System ID LAG partner's system ID assigned by the LACP protocol (i.e., its MAC address).
• Partner Port

Displaying LACP Port Statistics

Use the LACP Port Statistics page (click Monitor, LACP, Port Statistics) to display statistics on LACP
control packets crossing on each port.
FIG. 135 LACP Port Statistics
LACP Port Statistics parameters
• Port
• LACP Transmitted The number of LACP frames sent from each port.
• LACP Received
• Discarded
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch
Port Identifier.
Shows LACP status:
Yes - LACP is enabled and the port link is up.
No - LACP is not enabled or the port link is down.
Backup - The port could not join the aggregation group but will join if other port
leaves. Meanwhile it's LACP status is disabled.
Current operational value of the key for the aggregation port. Note that only ports
with the same key can aggregate together.
The Aggregation ID assigned to this LAG.
The partner port connected to this local port.
Port Identifier.
The number of LACP frames received at each port.
The number of unknown or illegal LACP frames that have been discarded at each
port.
Monitoring the NXA-ENET8-2POE
163