Displaying Qos Statistics; Displaying Qcl Status - AMX NXA-ENET8-2POE Operation/Reference Manual

Displaying QoS Statistics

Use the Queuing Counters page (click Monitor, Ports, QoS Statistics) to display the number of packets
processed by each service queue.
FIG. 118 Queuing Counters
Queuing Counters parameters
• Port
• Q# Receive/
Transmit

Displaying QCL Status

Use the QoS Control List Status page to show the QCE entries configured for different users or software
modules, and whether or not there is a conflict.
FIG. 119 QoS Control List Status
QoS Control List Status parameters
• User
• QCE#
• Frame Type
• Port
• Action
• Conflict
1.
Click Monitor, Ports, QCL Status.
2.
Select the user type to display from the drop-down list at the top of the page.
3.
If any of the entries display a conflict, click Resolve Conflict to release the resource required by a QCE.
Then click Refresh to verify that the conflict has been resolved.
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch
Port identifier.
The number of packets received and transmitted through the indicated queue.
Indicates the user (static entry, software module, or conflicting entry) of this QCE.
The information displayed in this field depends on the option selected in the drop-
down list at the top of this page (Combined, Static, Voice VLAN, Conflict).
QoS Control Entry index.
Indicates the type of frame to look for in incoming frames. Possible frame types
are: Any, Ethernet, LLC, SNAP, IPv4, IPv6.
Port identifier.
Indicates the classification action taken on ingress frame if the configured param-
eters are matched in the frame's content. If a frame matches the QCE, the follow-
ing actions will be taken:
Class (Classified QoS Class) - If a frame matches the QCE, it will be put in the
queue corresponding to the specified QoS class.
DP - The drop precedence level will be set to the specified value.
DSCP - The DSCP value will be set the specified value.
Displays QCE status. It may happen that resources required to add a QCE may
not available, in that case it shows conflict status as Yes, otherwise it is always
shows No. Please note that conflict can be resolved by releasing the resource
required by the QCE and pressing Refresh button.
Monitoring the NXA-ENET8-2POE
147