Power Cord Safety; France And Peru Only; Important! Read Before Making Connections - AMX NXA-ENET8-2POE Operation/Reference Manual

Compliances and Safety Statements

Power Cord Safety

Please read the following safety information carefully before installing the switch:
Installation and removal of the unit must be carried out by qualified personnel only.






France and Peru only

This unit cannot be powered from IT (Impédance à la terre) supplies. If your supplies are of IT type, this unit
must be powered by 230 V (2P+T) via an isolation transformer ratio 1:1, with the secondary connection point
labelled Neutral, connected directly to earth (ground).

IMPORTANT! Read Before Making Connections:

Before making connections, make sure you have the correct cord set. Check it (read the label on the cable)
against the following:
Power Cord Set
U.S.A. and Canada The cord set must be UL-approved and CSA certified.
Denmark
Switzerland
U.K.
Europe
2
The unit must be connected to an earthed (grounded) outlet to comply with international safety
standards.
Do not connect the unit to an A.C. outlet (power supply) without an earth (ground) connection.
The appliance coupler (the connector to the unit and not the wall plug) must have a configuration
for mating with an EN 60320/IEC 320 appliance inlet.
The socket outlet must be near to the unit and easily accessible. You can only remove power from
the unit by disconnecting the power cord from the outlet.
This unit operates under SELV (Safety Extra Low Voltage) conditions according to IEC 60950. The
conditions are only maintained if the equipment to which it is connected also operates under SELV
conditions.
The minimum specifications for the flexible cord are:
• No. 18 AWG - not longer than 2 meters, or 16 AWG.
• Type SV or SJ
• 3-conductor
The cord set must have a rated current capacity of at least 10 A
The attachment plug must be an earth-grounding type with NEMA 5-15P (15 A, 125 V)
configuration.
The supply plug must comply with Section 107-2-D1, Standard DK2-1a or DK2-5a.
The supply plug must comply with SEV/ASE 1011.
The supply plug must comply with BS1363 (3-pin 13 A) and be fitted with a 5 A fuse
which complies with BS1362.
The mains cord must comply with IEC 60227 (designation 60227 IEC 52).
The supply plug must comply with CEE7/7 ("SCHUKO").
The mains cord must comply with IEC 60227 (designation 60227 IEC 52).
IEC-320 receptacle.
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch