Configuring Mac-Based Vlans; Command Usage - AMX NXA-ENET8-2POE Operation/Reference Manual

Gigabit ethernet layer 2 poe switch
Hide thumbs Also See for NXA-ENET8-2POE:
Table of Contents

Advertisement

Configuring the NXA-ENET8-2POE
Port Isolation Configuration parameters
• Port Number
Ports within a private VLAN (PVLAN) are isolated from other ports which are not in the same PVLAN. Port
Isolation can be used to prevent communications between ports within the same PVLAN. An isolated port
cannot forward any unicast, multicast, or broadcast traffic to any other ports in the same PVLAN.
1.
Click Configuration, Private VLANs, Port Isolation.
2.
Mark the ports which are to be isolated from each other.
3.
Click Save.

Configuring MAC-based VLANs

Use the MAC-based VLAN Membership Configuration page to configure VLAN based on MAC addresses.
The MAC-based VLAN feature assigns VLAN IDs to ingress untagged frames according to the source MAC
addresses.
FIG. 90
MAC-based VLAN Membership Configuration
MAC-based VLAN Membership Configuration parameters
• MAC Address
• VLAN ID
• Port Members
When MAC-based VLAN classification is enabled, untagged frames received by a port are assigned to the
VLAN which is mapped to the frame's source MAC address. When no MAC address is matched, untagged
frames are assigned to the receiving port's native VLAN ID (PVID).

Command Usage




1.
Click Configuration, VCL, MAC-based VLANs.
2.
Enter an address in the MAC Address field.
3.
Enter an identifier in the VLAN field. Note that the specified VLAN need not already be configured.
4.
Specify the ports assigned to this VLAN.
5.
Click Save.
122
- Port identifier.
A source MAC address which is to be mapped to a specific VLAN. The MAC
address must be specified in the format xx-xxxx-xx-xx-xx.
VLAN to which ingress traffic matching the specified source MAC address is for-
warded. (Range: 1-4093)
The ports assigned to this VLAN.
Source MAC addresses can be mapped to only one VLAN ID.
Configured MAC addresses cannot be broadcast or multicast addresses.
When MAC-based and protocol-based VLANs are both enabled, priority is applied in this
sequence, and then port-based VLANs last.
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch

Advertisement

Table of Contents
loading

Table of Contents