Features; Switch Architecture; Network Management Options; Connectivity - AMX NXA-ENET8-2POE Operation/Reference Manual

NXA-ENET8-2POE Hardware Specifications (Cont.)
Compliances
Included Accessories
Other AMX Equipment:

Features

Switch Architecture

The NXA-ENET8-2POE employs a wire-speed, non-blocking switching fabric. This permits simultaneous
wire-speed transport of multiple packets at low latency on all ports. The NXA-ENET8-2POE also features
full-duplex capability on all ports, which effectively doubles the bandwidth of each connection.
The NXA-ENET8-2POE uses store-and-forward switching to ensure maximum data integrity. With store-and-
forward switching, the entire packet must be received into a buffer and checked for validity before being
forwarded. This prevents errors from being propagated throughout the network.

Network Management Options

With a comprehensive array of LEDs, the NXA-ENET8-2POE provides "At-a-glance" monitoring of network
and port status. The NXA-ENET8-2POE can be managed over the network via the Web Console. See the
Using the Web Console section on page 31 for details.

Connectivity





IEEE 802.3-2005 Ethernet, Fast Ethernet, and Gigabit Ethernet compliance ensures
compatibility with standards-based hubs, network cards and switches from any
vendor.
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch
• FCC Part 15 Class A
• IC CISPR 22 Class A
• CE EN 55022 Class A and EN 55024
• LVD EN 60950-1
• CB Scheme IEC 60950-1
• CSA 22.2 NO 60950-1
• Four adhesive foot pads
• Grounding screw
• Two brackets and eight screws
• Power Cord
• NXA-WAP1000 - 802.11a/b/g/n Wireless Access Point (FG2255-51/53)
• NXA-WAPZD1100 - Wireless LAN ZoneDirector (FG2255-75,
FG2255-54K – 60K)
8 10/100/1000 Mbps ports for easy Gigabit Ethernet integration and for protection of your
investment in legacy LAN equipment. See the Network Connections section on page 21 for details.
Auto-negotiation enables each RJ-45 port to automatically select the optimum communication
mode (half or full duplex) if this feature is supported by the attached device; otherwise the port can
be configured manually. See the Configuring Port Connections section on page 47 for details.
RJ-45 10/100/1000BASE-T ports support auto MDI/MDI-X pinout selection. See the Auto-
Negotiation / MDI-X Support section on page 27 for details.
Un-shielded (UTP) cable supported on all RJ-45 ports:
Category 3 or better for 10 Mbps connections

Category 5 or better for 100 Mbps connections

Category 5, 5e, 6 or better for 1000 Mbps connections

NXA-ENET8-2POE
7