Configuring Static Bindings For Arp Inspection - AMX NXA-ENET8-2POE Operation/Reference Manual

Port Mode Configuration
• Port
• Mode
1.
Click Configuration, Security, Network, ARP Inspection, Configuration.
2.
Enable ARP inspection globally, and on any ports where it is required.
3.
Click Save.

Configuring Static Bindings For ARP Inspection

Use the Static ARP Inspection Table to bind a static address to a port. Table entries include a port identifier,
VLAN identifier, source MAC address in ARP request packets, and source IP address in ARP request packets.
FIG. 61 Static ARP Inspection Table
ARP Inspection Configuration parameters
• Port
• VLAN ID
• MAC Address
• IP Address
ARP Inspection uses the DHCP snooping bindings database for the list of valid IP-to-MAC address bindings.
Static ARP entries take precedence over entries in the DHCP snooping bindings database. The switch first
compares ARP packets to any entries specified in the static ARP table. If no static entry matches the packets,
then the DHCP snooping bindings database determines their validity.
1.
Click Configuration, Network, Security, ARP Inspection, Static Table.
2.
Click Add new entry.
3.
Enter the required bindings for a given port.
4.
Click Save.
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch
Port identifier
Enables Dynamic ARP Inspection on a given port. Only when both Global Mode
and Port Mode on a given port are enabled, will ARP Inspection be enabled on a
given port. (Default: Disabled)
Port identifier.
ID of a configured VLAN (Range: 1-4094)
Allowed source MAC address in ARP request packets.
Allowed source IP address in ARP request packets.
Configuring the NXA-ENET8-2POE
83