Displaying Information About Vlans; Vlan Membership - AMX NXA-ENET8-2POE Operation/Reference Manual

Gigabit ethernet layer 2 poe switch
Hide thumbs Also See for NXA-ENET8-2POE:
Table of Contents

Advertisement

Monitoring the NXA-ENET8-2POE
MAC Address Table parameters
• Start from VLAN #
• MAC address #
with # entries per
page
• Type
• VLAN
• MAC Address
• Port Members

Displaying Information About VLANs

Use the monitor pages for VLANs to display information about the port members of VLANs, and the VLAN
attributes assigned to each port.

VLAN Membership

Use the VLAN Membership Status page to display the current port members for all VLANs configured by a
selected software module.
FIG. 157
VLAN Membership Status
VLAN Membership Status parameters
• VLAN User
• VLAN ID
• Port Members
1.
To display VLAN members, click Monitor, VLANs, VLAN Membership.
2.
Select a software module from the drop-down list on the right side of the page.
178
Select the starting point in the table.
Select the starting point in the table.
Indicates whether the entry is static or dynamic. Dynamic MAC addresses are
learned by monitoring the source address for traffic entering the switch. To config-
ure static addresses, refer to the Configuring The MAC Address Table section on
page 117.
The VLAN containing this entry.
Physical address associated with this interface.
The ports associated with this entry.
A software module that uses VLAN management services to configure VLAN
membership and VLAN port settings such as the PVID or untagged VLAN ID. This
switch supports the following VLAN user modules:
Static: Ports statically assigned to a VLAN through the CLI, Web or SNMP.
NAS: Provides port-based authentication, which involves communications
between a Supplicant, Authenticator, and an Authentication Server.
MVR: Eliminates the need to duplicate multicast traffic for subscribers in each
VLAN. Multicast traffic for all channels is sent only on a single (multicast) VLAN.
Voice VLAN: A VLAN configured specially for voice traffic typically originating
from IP phones.
MSTP: The 802.1s Multiple Spanning Tree protocol uses VLANs to create
multiple spanning trees in a network, which significantly improves network
resource utilization while maintaining a loop-free environment.
Combined: Shows information for all active user modules.
A VLAN which has created by one of the software modules.
The ports assigned to this VLAN.
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch

Advertisement

Table of Contents
loading

Table of Contents