Configuring Tag Classification For Tagged Frames; Configuring Egress Port Scheduler; Showing An Overview Of The Queue Mode And Weight Used By Egress Ports - AMX NXA-ENET8-2POE Operation/Reference Manual

Configuring Tag Classification For Tagged Frames

FIG. 96
QoS Ingress Port Tag Classification
1.
Click Configuration, QoS, Port Classification.
2.
Click on the value displayed in the Tag Class field.
3.
Set the tag classification mode to Disabled to use the default QoS class and DP level for tagged frames,
or to Enabled to use the mapped versions of PCP and DEI for tagged frames.
4.
Click Save.

Configuring Egress Port Scheduler

Use the QoS Egress Port Schedulers page to show an overview of the QoS Egress Port Schedulers, including
the queue mode and weight. Click on any of the entries in the Port field to configure egress queue mode, queue
shaper (rate and access to excess bandwidth), and port shaper.

Showing An Overview of the Queue Mode and Weight Used by Egress Ports

FIG. 97
Displaying Egress Port Schedulers
QoS Egress Port Schedulers parameters
Displaying QoS Egress Port Schedulers
• Port
• Mode
• Weight
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch
Port identifier.
Shows the scheduling mode for this port.
Shows the weight of each egress queue used by the port.
Configuring the NXA-ENET8-2POE
129