Port And System Status Leds - AMX NXA-ENET8-2POE Operation/Reference Manual

NXA-ENET8-2POE

Port and System Status LEDs

The NXA-ENET8-2POE includes a LED display panel on the front panel for key system and port indications
that simplify installation and network troubleshooting (FIG. 4):
Power Status LED
Diagnostics Status LED
FIG. 4 Port and System Status LEDs
The following tables describe the behavior of the front panel LEDs:
Port Status LEDs
LED
Gigabit Ethernet Ports (Ports 1-8)
Link/Activity/Speed
SFP Gigabit Ethernet Ports (Ports 9-10)
(Link/Activity)
System Status LEDs
LED
Power
Diag
PoE
10
PoE Status LEDs (ports 1 - 8)
Ethernet Port Status LEDs (ports 1 - 8)
(Link/Activity/Speed)
Condition Status
On/Flashing Amber Port has established a valid 10/100 Mbps network connection.
Flashing indicates activity.
On/Flashing Green Port has established a valid 1000 Mbps network connection.
Flashing indicates activity.
Off There is no valid link on the port.
On/Flashing Amber Port has established a valid 10/100 Mbps network connection.
Flashing indicates activity.
On/Flashing Green Port has established a valid 1000 Mbps network connection.
Flashing indicates activity.
Off There is no valid link on the port.
Condition Status
On Green The unit's internal power supply is operating normally.
Off The unit has no power connected.
Flashing Amber Continuous flashing of the LED indicates that the diagnostics test
(continuous) has detected a fault.
Flashing Amber If the LED flashes for 10 seconds or less, the system diagnostic test
is in progress.
Off The system diagnostic test has completed.
On Amber Powered device connected.
Off No powered device connected.
SPF Port Status LEDs (ports 9 - 10)
(Link/Activity/Speed)
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch