Displaying Information On Lacp; Displaying An Overview Of Lacp Groups; Displaying Lacp Port Status - AMX NXA-ENET8-2POE Operation/Reference Manual

Monitoring the NXA-ENET8-2POE
RADIUS Details parameters (Cont.)
Other Info
• State
• Round-Trip Time

Displaying Information on LACP

Use the monitor pages for LACP to display information on LACP configuration settings, the functional status
of participating ports, and statistics on LACP control packets.

Displaying an Overview of LACP Groups

Use the LACP System Status page (click Monitor, LACP, System Status) to display an overview of LACP
groups.
FIG. 133
ACP System Status
ACP System Status parameters
• Aggr ID
• Partner System ID LAG partner's system ID (MAC address).
• Partner Key
• Last Changed
• Local Ports

Displaying LACP Port Status

Use the LACP Port Status page (click Monitor, LACP, Port Status) to display information on the LACP
groups active on each port.
FIG. 134 LACP Port Status
162
The current state of the server. It takes one of the following values:
Disabled - The server is disabled.
Not Ready- The server is enabled, but IP communication is not yet up and
running.
Ready - The server is enabled, IP communication is up and running, and the
RADIUS module is ready to accept accounting attempts.
Dead (X seconds left) - Accounting attempts were made to this server, but it did
not reply within the configured timeout. The server has temporarily been
disabled, but will get re-enabled when the dead-time expires. The number of
seconds left before this occurs is displayed in parentheses. This state is only
reachable when more than one server is enabled.
The time interval (measured in milliseconds) between the most recent Response
and the Request that matched it from the RADIUS accounting server. The granu-
larity of this measurement is 100 ms. A value of 0 ms indicates that there hasn't
been round-trip communication with the server yet.
The Aggregation ID associated with this Link Aggregation Group (LAG).
The Key that the partner has assigned to this LAG.
The time since this LAG changed.
Shows the local ports that are a part of this LAG.
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch