AMX NXA-ENET8-2POE Operation/Reference Manual page 147

QoS Control List Configuration parameters (Cont.)
QoS Control List (Cont.)
• DMAC
• VID
• Action
QCE Configuration
• Port Members
Key Parameters
• Tag
• VID
• PCP
• DEI
• SMAC
• DMAC Type
• Frame Type
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch
The type of destination MAC address. Possible values are: Any, Broadcast, Multi-
cast, Unicast.
VLAN identifier. (Range: 1-4095)
Indicates the classification action taken on ingress frame if the configured param-
eters are matched in the frame's content. If a frame matches the QCE, the follow-
ing actions will be taken:
Class (Classified QoS Class) - If a frame matches the QCE, it will be put in the
queue corresponding to the specified QoS class.
DPL - The drop precedence level will be set to the specified value.
DSCP - The DSCP value will be set the specified value.
The ports assigned to this entry.
VLAN tag type. (Options: Any, Tag, Untag; Default: Any)
VLAN identifier. (Options: Any, Specific (1-4095), Range; Default: Any)
Priority Code Point (User Priority). (Options: a specific value of 0, 1, 2, 3, 4, 5, 6,
7, a range of 0-1, 2-3, 4-5, 6-7, 0-3, 4-7, or Any; Default: 0)
Drop Eligible Indicator. (Options: 0, 1 or Any)
The OUI field of the source MAC address. Enter the first three octets (bytes) of the
MAC address, or Any.
The type of destination MAC address. (Options: Any, BC (Broadcast), MC (Multi-
cast), UC (Unicast)
The supported types are listed below:
Any - Allow all types of frames.
Ethernet - This option can only be used to filter Ethernet II formatted packets.
(Options: Any, Specific. 600-ffff hex; Default: ffff)
Note that 800 (IPv4) and 86DD (IPv6) are excluded.
A detailed listing of Ethernet protocol types can be found in RFC 1060. A few
of the more common types include 0800 (IP), 0806 (ARP), 8137 (IPX).
LLC - Link Logical Control includes the following settings:
SSAP Address - Source Service Access Point address. (Options: Any,
Specific (0x00-0xff); Default: 0xff)
DSAP Address - Destination Service Access Point address. (Options: Any,
Specific (0x00-0xff); Default: 0xff)
Control - Control field may contain command, response, or sequence
information depending on whether the LLC frame type is Unnumbered,
Supervisory, or Information. (Options: Any, Specific (0x00-0xff); Default: 0xff)
SNAP - SubNetwork Access Protocol can be distinguished by an OUI and a
Protocol ID. (Options for PID: Any, Specific (0x00-0xffff); Default: Any)
If the OUI is hexadecimal 000000, the protocol ID is the Ethernet type
(EtherType) field value for the protocol running on top of SNAP.
If the OUI is that of a particular organization, the protocol ID is a value
assigned by that organization to the protocol running on top of SNAP.
In other words, if value of the OUI field is 00-00-00, then value of the PID will
be etherType (0x0600-0xffff), and if value of the OUI is other than 00-00-00,
then valid value of the PID will be any value from 0x0000 to 0xffff.
Configuring the NXA-ENET8-2POE
137