Configuring The Scheduler Mode, Egress Queue Mode, Queue Shaper, And Port Shaper Used By Egress Ports; Configuring Egress Port Shaper - AMX NXA-ENET8-2POE Operation/Reference Manual

Configuring the Scheduler Mode, Egress Queue Mode, Queue Shaper, and Port Shaper Used
by Egress Ports
FIG. 98 Configuring Egress Port Schedulers and Shapers
1.
Click Configuration, QoS, Port Scheduler.
2.
Click on any of the entries in the Port field.
3.
Set the scheduler mode, the queue shaper, queue scheduler (when the scheduler mode is set to Weighted),
and the port shaper.
4.
Click Save.

Configuring Egress Port Shaper

Use the QoS Egress Port Shapers page to show an overview of the QoS Egress Port Shapers, including the rate
for each queue and port. Click on any of the entries in the Port field to configure egress queue mode, queue
shaper (rate and access to excess bandwidth), and port shaper.
FIG. 99 QoS Egress Port Shapers
QoS Egress Port Schedulers parameters
Displaying QoS Egress Port Schedulers
• Port
• Shapers
Configuring QoS Egress Port Scheduler, Queue Scheduler and Port Shapers
This configuration page can be access from the Port Scheduler or Port Shaper page.
Refer to the description of these parameters in the Configuring Egress Port Scheduler section on
page 129.
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch
Port identifier.
Shows the queue shaper rate and port shaper rate.
Configuring the NXA-ENET8-2POE
131