Qce Modification Buttons - AMX NXA-ENET8-2POE Operation/Reference Manual

Configuring the NXA-ENET8-2POE
QoS Control List Configuration parameters (Cont.)
Key Parameters (Cont.)
• Frame Type
(Cont.)
Action Parameters
• Action
1.
Click Configuration, QoS, QoS Control List.
2.
Click the button to add a new QCE, or use the other QCE modification buttons to specify the editing
action (i.e., edit, delete, or moving the relative position of entry in the list).
3.
When editing an entry on the QCE Configuration page, specify the relevant criteria to be matched, and
the response to a match.
4.
Click Save.

QCE Modification Buttons

Button
138
IPv4 - IPv4 frame type includes the following settings:
Protocol - IP protocol number. (Options: Any, UDP, TCP, or Other (0-255))
Source IP - Source IP address. (Options: Any, Specific) To configure a
specific source IP address, enter both the address and mask format. The
address and mask must be in the format x.y.z.w where x, y, z, and w are
decimal numbers between 0 and 255. When the mask is converted to a 32-
bit binary string and read from left to right, all bits following the first zero must
also be zero
IP Fragment - Indicates whether or not fragmented packets are accepted.
(Options: Any, Yes, No; Default: Any) Datagrams may be fragmented to
ensure they can pass through a network device which uses a maximum
transfer unit smaller than the original packet's size.
DSCP - Diffserv Code Point value. (Options: Any, specific value of 0-63, BE,
CS1-CS7, EF or AF11-AF43, or Range; Default: Any)
IPv6 - IPv6 frame type includes the same settings as those used for IPv4, except
for the Source IP. When configuring a specific IPv6 source address, enter the
least significant 32 bits (a.b.c.d) using the same type of mask as that used for an
IPv4 address.
Sport - Source TCP/UDP port. (Any, Specific/Range: 0-65535)
Dport - Destination TCP/UDP port. (Any, Specific/Range: 0-65535)
Indicates the classification action taken on ingress frame if the configured param-
eters are matched in the frame's content. If a frame matches the QCE, the follow-
ing actions will be taken:
Class (Classified QoS Class) - If a frame matches the QCE, it will be put in the
queue corresponding to the specified QoS class, or placed in a queue based on
basic classification rules. (Options: 0-7, Default (use basic classification);
Default setting: 0)
DPL - The drop precedence level will be set to the specified value or left
unchanged. (Options: 0-1, Default; Default setting: Default)
DSCP - The DSCP value will be set to the specified value or left unchanged.
(Options: 0-63, BE, CS1-CS7, Default (not changed); Default setting: Default)
Description
Inserts a new ACE before the current row.
Edits the ACE.
Moves the ACE up the list.
Moves the ACE down the list.
Deletes the ACE.
The lowest plus sign adds a new entry at the bottom of the list.
NXA-ENET8-2POE Gigabit Ethernet Layer 2 PoE Switch