Safety Compliance; Warning: Fiber Optic Port Safety; Avertissment: Ports Pour Fibres Optiques - Sécurité Sur Le Plan Optique; Warnhinweis: Faseroptikanschlüsse - Optische Sicherheit - AMX NXA-ENET24 Hardware Installation Manual

Safety Compliance

Warning: Fiber Optic Port Safety

Avertissment: Ports pour fibres optiques - sécurité sur le plan optique
Warnhinweis: Faseroptikanschlüsse - Optische Sicherheit

Please read the following safety information carefully before installing the switch:

Installation and removal of the unit must be carried out by qualified personnel only.

France and Peru only

This unit cannot be powered from IT
230 V (2P+T) via an isolation transformer ratio 1:1, with the secondary connection point labelled Neutral,
connected directly to earth (ground).
†
Impédance à la terre
NXA-ENET24 Hardware Installation Guide
When using a fiber optic port, never look at the transmit laser while
it is powered on. Also, never look directly at the fiber TX port and
fiber cable ends when they are powered on.
Ne regardez jamais le laser tant qu'il est sous tension. Ne regar-
dez jamais directement le port TX (Transmission) à fibres optiques
et les embouts de câbles à fibres optiques tant qu'ils sont sous
tension.
Niemals ein Übertragungslaser betrachten, während dieses einge-
schaltet ist. Niemals direkt auf den Faser-TX-Anschluß und auf die
Faserkabelenden schauen, während diese eingeschaltet sind.
The unit must be connected to an earthed (grounded) outlet to comply with international safety
standards.
Do not connect the unit to an A.C. outlet (power supply) without an earth (ground) connection.
The appliance coupler (the connector to the unit and not the wall plug) must have a configuration
for mating with an EN 60320/IEC 320 appliance inlet.
The socket outlet must be near to the unit and easily accessible. You can only remove power from
the unit by disconnecting the power cord from the outlet.
This unit operates under SELV (Safety Extra Low Voltage) conditions according to
IEC 60950. The conditions are only maintained if the equipment to which it is connected also
operates under SELV conditions.
†
supplies. If your supplies are of IT type, this unit must be powered by
Compliances
3