Axlink Keypad Port (4-Pin Captive-Wire); Config Dip Switch - AMX SDX-510M-DX Instruction Manual

AXLINK KEYPAD Port (4-pin captive-wire)

The AXLINK KEYPAD port allows the switcher to provide power and data to up to two AMX AxLink Keypads.
AxLink functionality requires a NetLinx Master to be present on the connected network. The AXLINK KEYPAD LED
indicating activity on the port is located on the front panel of the device. See the LEDs section on page 14 for more
information.
FIG. 6 displays the AxLink ports on the SDX-410-DX and SDX-510M-DX.
FIG. 6 AxLink Ports
The AxLink port can be used to supply power to downstream AxLink-compatible devices. The port is capable of
providing at least 2 Amps of 12V power.
For information on wiring for the AxLink port, see the AXLINK KEYPAD Port section on page 25.

CONFIG DIP Switch

Use the Configuration DIP switch to enable/disable the LAN ports, set the DXLink mode, and set network connectivity.
All DIP switches are initially set to the OFF position. DIP switch settings are read on reboot. Any changes to the DIP
switch settings are not acted upon until after you reboot the device.
FIG. 7 displays the CONFIG DIP switch.
FIG. 7 CONFIG DIP switch
The DIP switches are numbered 1-4 from left to right. The following table lists the settings for each DIP switch.
DIP Switch Settings
Pin Description
1 Enable/Disable LAN 10/100
2 Set the DXLink mode
3 Network Connectivity
4 Not Defined
Instruction Manual - Solecis Digital Switchers
SDX-410-DX
ON
Enables all External LAN 10/100
ports
Maintains ability to read the DIP switch but takes no action. Always
responds to the ?DXLINK command as an endpoint.
IP for the internal processor is
enabled. This switch does not
affect the External Ethernet
ports.
No action
Device Connectors
SDX-510M-DX
OFF
Disables all External LAN 10/100
ports
IP for the internal processor is
disabled. This switch does not
affect the External Ethernet ports.
No action
15