Loading An Ir File To A Tvm-1600; Display Device Ir Control; Important Notes About Ir Control; Configuring A Display Device's Ir Protocol - AMX Endeleo TVM-1600 Operation/Reference Manual

Loading an IR File To a TVM-1600

Previously saved IR Files on a PC can be uploaded to the TVM-1600;
1. At the command prompt on the PC, navigate to the location where the IR File is saved (FIG. 39).
2. Enter the following command:
FIG. 39 Putting an IR File on the TVM-1600
3. Push Enter to execute the command.
4. Upon completion a successful transfer message is displayed (FIG. 40).
FIG. 40 Successful transfer of IR File

Display Device IR Control

The Endeleo Managed TV solution supports the learning of the IR control protocols for display devices
(e.g. CRT TV, LCD, Plasma, Projector).
An IR Blaster is connected to the TVM-RX03 and attached to the TV screen over its IR sensor to accept
IR commands from the Endeleo RX.

Important Notes About IR Control

Configuring a Display Device's IR protocol

The two stages for learning IR Protocols are:
1. Train the TVM-RX03 to understand the timing sequences of the display device remote control
protocol.
2. Learn the actual IR code for specific functions on the device's remote control e.g. power off.

Learning the IR Protocol Used By the Display Device

1. Ensure a console session has been opened on the TVM-1600. The configuration settings for the
Terminal session are:
2. A TVM-RX03 unit needs to be connected to port one of the TVM-1600.
TVM-1600 Endeleo Managed TV Distribution Hub
tftp –i [IP address of hub] put [name of ir table].hub
All devices requiring IR control must be connected to the TVM-1600 via the IR blaster port on
the rear of the TVM-1600.
The part number for the 4-Way IR Splitter necessary for TVM Central Device Control is
TVM-IR04.
• Baud Rate: 9600 bps
• Data Bits: 8
• Parity: None
• Stop Bits: 1
• Flow Control: None
IR Learning and IR Device Control
37