Table of Contents
Advertisement
Setting Up
User's Manual
This section describes how to assemble the printer and connect the
power cord after choosing a suitable location for the printer and
checking that you received all the parts.
Preparing the Print Unit
The print unit is an assembly made up the developer unit and the
drum unit. You must assemble these two units into the print unit. Be
sure to remove the two protective materials from the developer unit
and drum unit. This operation must be done before connecting the
power cord.
Caution:
Be careful with the print unit's drum (the green surface). The drum
is easily damaged by contamination or by exposure to light for more
than three minutes. Follow these guidelines:
• Never open the shutter under the drum unit before until you are
ready to install the print unit.
• Never touch or scratch the drum surface.
• When the print unit is not in the printer, close the shutter of the
drum unit and store the print unit in a dark place or cover it with a
clean sheet of paper.
• When the print unit is in the printer, keep the printer upper door
closed. If you must work inside the printer for more than three
minutes, remove the print unit and store it in a dark place.
• If you store the print unit out of the printer, it may be
contaminated by dust. This may cause a smudge on the page.
When storing the print unit out of the printer, wrap it with paper
or something.
To install the print unit, follow these steps:
1. Remove the developer unit and the drum unit from the package.
Caution:
Never open the shutter of the drum unit to avoid scratching the
green surface of the drum.
Setting Up
GETTING
STARTED
1-7
Advertisement
Table of Contents
