NEC XN120 Feature Manual page 206

Features
To erase a previously recorded VRS message:
1. Press idle SPK key.
OR
At a single line telephone, lift handset.
2. Dial the Voice Mail service code in 11-12-39 (default - 884)
3. Enter your mailbox number followed by # (and password if enable).
4. Dial 37# (Erase message 1).
You'll hear, "Do you wish to erase a announce message. Please dial 0 followed by # to accept."
5. Dial 0# to erase a message.
6. Hang up.
Selecting message to play
1. If calling from a keyphone with 'Change Attendant Message' key (code 71 + mailbox), press that
key, if calling from an SLT or a keyphone without 'Change Attendant Message' key, the answering
message cannot be changed.
2. The 'Change Attendant Message' key toggles to select the answering message and the lamp indicates
which message is selected :
Message 1 = Lamp extinguished
Message 2 = lamp steady
Message 3 = lamp flashing.
If "Busy Line Attendant Feature" has been set at installation, answering message 3 will play
when the extension is busy, therefore messages 1 & 2 can only be used normal answering for
Automated Attendant.
Setting Password:
You can set a four digit password to your mailbox.
1. If calling from a keyphone with Voice Mail Access key for the mailbox (code 67 + mailbox) press
the key, if calling from an SLT or a keyphone without Voice Mail access key dial the Voice Mail
Access code in 11-12-39 (default - 884) and enter your mailbox number (and password if
enabled).
2. Dial service code 65#
3. Enter your new four digit password followed by #.
4. Your password will be spoken back to you followed by the prompt "Please dial 0# for yes, or dial
1# for no".
5. Enter 0 then # to confirm.
6. You will be prompted "your password has been registered. Service code please"
7. Hang up.
Deleting your password:
1. If calling from a keyphone with Voice Mail Access key for the mailbox (code 67 + mailbox) press
the key, if calling from an SLT or a keyphone without Voice Mail access key dial the Voice Mail
Access code in 11-12-39 (default - 884) and enter your mailbox number (and password if
enabled).
2. Dial service code 65#.
3. At password prompt dial '9999' followed by #.
4. You will be prompted "your password will be erased, dial 0# for yes, or dial 1# for no".
5. Dial 0 then #.
6. You will be prompted that you password has been erased.
Features Manual
204