The Menu System - Perle IOLAN + Rack User And Administration Manual

+ - User and Administration Guide
IOLAN
2.5 The Menu
System
16
The next prompt displayed is local>, which is the Command
Line Interface (CLI) prompt.
Note: If there are any problems, check the cable you are
using (this is the most common error). Port 1 is configured to
provide error messages should any problems occur. See
Troubleshooting & Maintenance (Appendix B) for more
information on problems.
You can now move to The Menu System.
You should now be at the Command Line Interface (CLI) of
the IOLAN+ as designated by the local> prompt. If you
would like to continue in CLI mode refer to Appendix A , but
we recommend the menu system.
Set the terminal emulation type and begin using the menus.
The following are the terminal options:
ansi, dumb, vt100, wyse50, wyse60, tvi925,
ibm3151, vt320, falco50, hp700
The default setting is 'dumb'. To set the menu interface to
your emulation simply type set term with your option.
Example:
local> set term ansi
Note: For Falco50 type local> set term falco
To switch from the command line interface to the menu
interface, at the local> prompt enter:
set menu
The Connections Menu should now be displayed.
This menu displays the current state of the four possible
connections. There are no active connections.