Perle IOLAN + Rack User And Administration Manual page 118

+ - User and Administration Guide
IOLAN
COPY
DIAL
DISCONNECT
EXIT
112
The command will use telnet or rlogin
depending on what is set in the Options section
of the Port Menu .
Example:
local> connect
Host/IP Address> microart
TCP Port> 23
Note: If the user presses the return at the port prompt,
the unit defaults to port 23 which is the standard
telnet port (or 513, the standard rlogin port). This
option is not available when using remote
administration or if the port secure mode is WAN.
Syntax:
copy <source port> <destination> [destination]...
Description: This command copies one port setup to another
allowing easy setup if the ports are the same
configuration. Administrative level is required
to change. Note that multiple destination ports
can be specified separated by spaces.
Syntax:
dial
Description: This command shows the status of the dial-out
interface and would be used for monitoring
dial-out connections.
Syntax:
disconnect <session-number>
Description: This command allows a user to disconnect (close)
one or all of their existing TCP connections.
Syntax:
exit
Description: This function causes the user to exit the
IOLAN+, closing down any sessions and
resetting the port.