Perle IOLAN + Rack User And Administration Manual page 117

A.3 Command
Descriptions
ARP
CLEAR
CONNECT
2. Enter set server. This will lead you to:
ADMIN:local> set server
Type '?' at prompt to see list of valid options;
<Esc> to abort changes.
Name : ronald
Debug mode : 0
IP address : 204.17.209.18
Subnet mask : 255.255.255.0
and so on...
3. Enter reboot .
ADMIN:local> reboot
There are a large number of commands available for the
IOLAN+, these are detailed below:
Syntax:
arp [flush]
Description: This command by itself will show the IOLANs
arp table (IP address, Ethernet address, flags).
In the admin mode, using arp flush will clear all
the entries in the arp table. This is used to clear
arp entries when you want to change the
Ethernet address of a device.
Syntax:
clear
Description: This command clears the screen.
Syntax:
connect [host] [port]
Description: This makes a telnet or rlogin connection to the
indicated host or IP address. If the user omits
the host/IP address then the IOLAN+ asks for it
as shown below.
Command Line Interface
111