Table of Contents
Advertisement
324 Port InfiniBand FDR Switch Platform Hardware Installation Guide
Step 2.
Step 3.
1.8
Inserting a Management Module
Step 1.
Step 2.
Step 3.
Push the latch release.
1.9
Inserting a Spine Board
UID
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Mellanox Technologies
Carefully set the leaf board into the side guide rails and slowly slide the board
into the chassis.
Catch the hooks onto the vertical bar and push the latch shut.
Start with the latches fully open, that is 45
Carefully seat the management module into the slot and slowly slide the board
into the chassis until the ejectors begin to engage on the chassis edge.
Press the ejectors inward until the locks snap. This indicates that the board is
fully seated.
Figure 26: Ejector Latch
Management Module /Spine
Figure 27: Spine Board Insertion
Open the Ejector Latches
1
3
5
7
9
11
13
15
17
2
4
6
8
10
12
14
16
18
Start with the latches fully open, that is 45
Hold the spine board by the sides with both latches fully open.
Insert the board into its rail. The board should slide in without resistance.
Push the board in until the hooks on the latches are touching the vertical bar.
Now press both latches inward simultaneously. You should feel the latches are
hooked into the front panel.
Press both latches applying some force to close them completely. The locking
latch will engage.
o
to the front panel of the leaf.
Management Module /Spine
19
21
23
25
27
29
31
20
22
24
26
28
30
32
o
to the front panel of the leaf.
Rev 1.0
33
35
34
36
31
Advertisement
Table of Contents
