General Preparations; Power Supply Unit Extraction; Figure 4 - Power Side Of The Switch; Figure 5 - Switch With 1 Psu/ 2 Psus Removed - Mellanox Technologies MetroDX MTX6000-2SFS Dismantling Manual

Mellanox 1036/6018/6015/6025/6036 SwitchX® and Metrox® Switch Systems Dismantling Guide
2.2

General Preparations

The switch system is assembled using Philips screws and handles with snap in latches for
modules. To disassemble the switch system you will need a small Philips screwdriver.
The pictures displayed in the following pages provide visual guidance explaining how to
remove the modules from the mechanical base.
2.3

Power Supply Unit Extraction

K O
K O
To extract the PSU:
1. Remove the power cord from the power supply unit.
2. Grasping the handle with one hand, push the latch release with your thumb while pulling
the handle outward.
3. Remove the PSU.
4. Repeat the procedure for the second PSU if there is one.
5. If there is only one PSU, remove the blank cover.
Figure 4 – Power Side of the Switch
K O
o x n a e l l M

Figure 5 - Switch with 1 PSU/ 2 PSUs Removed

Mellanox Technologies Confidential
K O
C I 2
Rev 1.1
11