InfiniBand FDR Switch Platform Hardware User Manual
You will most likely need extra room for cable bending on the connector side of the chas-
sis and should plan to keep the spine side as close to the rack door as possible, thus hav-
ing more room for the cables. See Figure 1 on page 29.
3. Clip 4 caged nuts into the holes in the rack you will be using to connect the shelf
brackets. Check that both sides of the shelf are at the same level in the rack.
4. Insert 2 caged nuts for the filler panel.
5. Using two of the bolts for each rail slide, install the rail slides onto the rack. Check
that both sides of the switch, left and right, are the same level in the rack.
Mellanox Technologies
Figure 5: Placement of Chassis in Rack
Doors
19" (482.6mm)
Shelf
Chassis
Insufficient room for recommended
bending radius
Doors
Figure 6: Inserting the Caged Nuts for the Shelf
Top of shelf
Bottom of shelf
Do not use this
hole for the
shelf. This hole
is for the filler
panel.
RACK
Cable with
recommended
bending radius
Connector side
Spine side
21
20
19
23