ARspace Alarms; Cdi Scale / Alarms - Garmin GPS 400W Pilot's Manual & Reference

Airspace Alarms
To set the airspace warning messages or change
the altitude buffer:
1. Select "Arspace Alarms" from the setup 1
page.
Turn the large right knob to hghlght the
2.
"On"/"Off" field next to the desred arspace
type.
3. Turn the small right knob to select "On" or
"Off", as desred. Press ENT to accept the
selecton.
4. To change the alttude buffer, turn the large
right knob to hghlght the "Alttude Buffers"
field. Use the small and large right knobs
to enter the desred buffer dstance. Press ENT
when finshed.
NOTE: When an approach has been loaded into
the active flight plan, airspace alert messages
will be disabled within 30 NM of the destination
airport.

CDI Scale / Alarms

To change the CDI scale:
1. Select "CDI / Alarms" from the Setup 1 page.
2. The flashng cursor hghlghts the "Selected
CDI" field. Turn the small right knob to select
the desred CDI scale. The selected scale and
any lower scale settngs wll be used durng
the varous phases of flght.
3. Press ENT to accept the selected scale. The
"System CDI" field wll dsplay the CDI scale
currently n use. The "System CDI" settng may
dffer from the "Selected CDI" dependng upon
the current phase of flght.
NOTE: The CDI scale is always measured in nauti-
cal miles, regardless of the current distance units
of measure selected on the units/mag var page.
190-00356-00 Rev B
9 - AUX PAGES
Setup 1
167