FlyNg The Ils Approach - Garmin GPS 400W Pilot's Manual & Reference

5 - PROCEDURES
ILS Approach
Flagstaff (AZ) Pulliam
ILS DME Rwy 21


4. A remnder message appears, ndcatng that
GPS can only be used for approach montor-
ng. As mentoned, you wll need to use the
VLOC recever for ths approach. Press ENT to
acknowledge the message.
When you "Load?" (or "Activate?") an ILS approach,
the ILS frequency is automatically placed in the standby
field of the VLOC window. To use this frequency, simply
press the VLOC flip-flop key to place it in the active
frequency field.
104
430W Only
Flying the ILS Approach
When you "Activate?" an ILS approach, automatic
switching of the external CDI is enabled (unless turned
off from the CDI/Alarms Page). When you are established
on the inbound course to the FAF, the external CDI
guidance will automatically switch from "GPS" (shown
in green text) to "VLOC" (shown in white text). If you
have forgotten to activate the ILS frequency (step #4 below),
automatic selection of "VLOC" will not occur.
1.
2.
DO NOT USE FOR
NAVIGATION
3.
4.
190-00356-00 Rev B
Wthn 31 nautcal mles of KFLG, the GNS
430W wll swtch from en route mode to term-
nal mode and the CDI scale wll transton from
2.0 to 1.0 nautcal mles, full scale deflecton.
If you haven't already actvated the approach
(n steps on prevous page), be sure to do so
when cleared for the approach.
As you approach the IAF (SHUTR), a waypont
alert ("LT TO 030° x S") wll appear n the lower
rght corner of the screen.
If you haven't already done so, press the VLOC
flip-flop key to actvate the ILS frequency. If
you forget ths step, the GNS 430W wll dsplay
a remnder message (wthn 2 NM of the FAF)
to actvate the ILS frequency.