Ident Audio And Volume; Vloc Window And Tuning - Garmin GPS 400W Pilot's Manual & Reference

Section 8
VLOC (VOR/Localizer/Glideslope)
Receiver Operations
The GNS 430W includes digitally-
tuned VOR/localizer and glideslope receiv-
ers with the desired frequency selected on
a VLOC window, along the left-hand side
of the display. Frequency selection is performed by
pressing the small left knob and turning the small
and large left knobs to select the desired frequency.

Ident Audio and Volume

VLOC ident is enabled by pressing the
VLOC volume knob. When VLOC ident
is enabled, an "ID" indication appears
in the upper right corner of the VLOC
window — to the immediate right of "VLOC".
Push for ident audio. Turn to
j
adjust audio volume.
VLOC audio volume is adjusted using the VLOC
volume knob. Turn the VLOC volume knob clock-
wise to increase volume, or counterclockwise to
decrease volume.
GNS 430W Only

VLOC Window and Tuning

VLOC frequencies are selected with the tuning
cursor in the standby VLOC frequency field, and using
the small and large left knobs to dial in the desired
frequency. The standby frequency always appears
below the active frequency. The active frequency is the
frequency currently in use.
v
y
The tuning cursor will remain in the COM window.
If you wish to select a VOR/localizer/ILS frequency,
press the small left knob momentarily to place the
cursor in the VLOC window.
NOTE: The tuning cursor will normally appear
in the COM window, unless placed in the VLOC
window by pressing the small left knob. When
the tuning cursor is in the VLOC window, it will
automatically return to the COM window after 30
seconds of inactivity.
190-00356-00 Rev B
8 - VLOC RECEIVER
Ident, Volume and Tuning
Push to toggle the tuning cursor
(small left knob) between COM
and VLOC windows. Turn to adjust
the kHz value (the portion after
the decimal point) of standby
VLOC frequency.
Turn to adjust the MHz value (the
portion before the decimal point)
of the standby VLOC frequency.
145