Garmin GPS 400W Pilot's Manual & Reference page 156

8 - VLOC RECEIVER
Auto-Tuning
To select a VOR/localizer/ILS frequency:
1. If the tunng cursor s not currently n the VLOC
wndow, press the small left knob momen-
tarly.
2. Turn the large left knob to select the desred
megahertz (MHz) value. For example, the
"117" porton of the frequency "117.80".
Turn the small left knob to select the desred
3.
klohertz (kHz) value. For example, the ".80"
porton of the frequency "117.80".
4. To make the standby frequency the actve
frequency, press the VLOC flip-flop key.
146
GNS 430W Only
Auto-Tuning
A frequency may also be quickly selected from the
database by simply highlighting the desired frequency
on the VOR page or the nearest VOR page and pressing
the ENT key. This process is referred to as auto-tuning.
Once a frequency is selected in the standby field, it
may be transferred to the active frequency by press-
ing the VLOC flip-flop key. (Auto-tuning can also
be performed from VLOC frequencies listed on the
NAVCOM, airport frequency, and nearest flight service
station pages.)
To select a VLOC frequency from the VOR or near-
est VOR pages:
1.
2.
3.
4.
5.
190-00356-00 Rev B
Select the desred page from the man pages.
(See page references on the precedng page.)
Press the small right knob momentarly to
actvate the flashng cursor.
Turn the large right knob to hghlght the
frequency for the desred VOR.
Press ENT to place the frequency n the standby
field of the VLOC wndow.
Press the VLOC flip-flop key to actvate the
selected frequency.